Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NEED HELP IN ROUTING AND SWITCHING, ACL(ACCESS CONTORL LIST) LAB.

Hello guys, Hope you doing good all.

I need a help in a scenerio at which,  I have created an ACL in router 0. Then, By applying "show run", it tells that i blocked the host,connected to lan network 192.168.5.0 at router 4..The host represents 192.168.5.2.Now my question is,by pinging 192.168.5.2 from pc0, it can not succeed. but why, from ping 192.168.5.2 to pc0 succeeds, as i have blocked it. ??  

2 REPLIES

Hi -

Hi -

Depends on a couple of factors.  Which interface is the ACL applied to and what direction (in / out)?  What are the contents of the ACL?

PSC

As Paul has said, we need to

As Paul has said, we need to see the contents of the ACL applied to R0 and also the config on the relevant 192.168.1.0 Layer 3 interface on R0

Thanks

33
Views
0
Helpful
2
Replies