I am not quite familiar with the concept of VLAN access-list. From what I cound understand, typical VACL configuration is like this:
vlan access-map Filter-VL7 10 action forward match mac address AllowThose ! vlan access-map Filter-VL7 20 action forward match ip address 101 ! vlan access-map Filter-VL7 30 action drop
It seems that you define the VACL by accepting some traffic based on ACL and then you drop packets that are not match.
I would like to know if it is possible to restrain traffic like ICMP, and telnet to a specific IP address and allowing all other IP traffic that is not going to that specific address. Any example on how this could be done, if feasible, would be greatly appreciated.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.