Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
245
Views
0
Helpful
1
Replies

Need help to find IOS command convertor

Go to solution
murugananthamamir
Level 1
Level 1

‎07-24-2013 11:41 PM - edited ‎03-07-2019 02:34 PM

Dar Folkz,

Is there any tools to convert the IOS commands to IOS-XE ?

If persist, please let me know .

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
InayathUlla Sharieff
Cisco Employee
Cisco Employee

‎07-25-2013 04:29 AM

Muru,

I have not seen any tool for this.

You have to refer the cli reference guide for the same.

http://www.cisco.com/en/US/docs/ios/ios_xe/preface/usingios_xe.html

http://www.cisco.com/en/US/docs/ios/preface/usingios.html

HTH

Regards

Inayath

*Plz rate if this is helpfull.

View solution in original post

0 Helpful
1 Reply 1

Go to solution
InayathUlla Sharieff
Cisco Employee
Cisco Employee

‎07-25-2013 04:29 AM

Muru,

I have not seen any tool for this.

You have to refer the cli reference guide for the same.

http://www.cisco.com/en/US/docs/ios/ios_xe/preface/usingios_xe.html

http://www.cisco.com/en/US/docs/ios/preface/usingios.html

HTH

Regards

Inayath

*Plz rate if this is helpfull.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card