Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Need help with installation new 1MFT Wic controller

I am tryig to install a T1 controller 1mft Wic in a 2811 router. I don't see the contoller to configure it. I do see it if I run sh diag but not in show config. What am I missing to register the card so can set it up for voice.

Thanks

12 REPLIES
New Member

Re: Need help with installation new 1MFT Wic controller

If it is a T1/E1 card, you need to first configure "card type t1 0 0", depending on what slot you have the card in.

New Member

Re: Need help with installation new 1MFT Wic controller

it is a daughter card in slot 0 but the router won't take card type as on option?

New Member

Re: Need help with installation new 1MFT Wic controller

What is the part number of the card?

New Member

Re: Need help with installation new 1MFT Wic controller

WIC Slot 0:

T1E1 (1 port) WAN daughter card

Hardware Revision : 0.0

Top Assy. Part Number : 800-22628-05

Board Revision : A0

Deviation Number : 0

Fab Version : 04

PCB Serial Number : FOC10520QNU

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Product (FRU) Number : VWIC2-1MFT-T1/E1

Version Identifier : V01

EEPROM format version 4

New Member

Re: Need help with installation new 1MFT Wic controller

So that card will do either T1 or E1, in global config, you should be able to use the card type command.

New Member

Re: Need help with installation new 1MFT Wic controller

TGO-MKE-Honeycreek-Router#

TGO-MKE-Honeycreek-Router#config t

Enter configuration commands, one per line. End with CNTL/Z.

TGO-MKE-Honeycreek-R(config)#card

TGO-MKE-Honeycreek-R(config)#card ?

% Unrecognized command

TGO-MKE-Honeycreek-R(config)#card

New Member

Re: Need help with installation new 1MFT Wic controller

Hmm. What version of IOS?

New Member

Re: Need help with installation new 1MFT Wic controller

Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.3(8)T8, RELEASE SOFTWARE (fc1)

I thought maybe I was loosing my mind. Very odd nothing seems to be working

New Member

Re: Need help with installation new 1MFT Wic controller

Well, I can't vouch for your mind ;), but it sure seems like it should be working. Maybe try a different slot, or a reload?

New Member

Re: Need help with installation new 1MFT Wic controller

maybe a reload of the IOS? I do have 2 cards and installed the second into another slot to see if that would make a difference but no luck. Strange it shows in sh diag but can't configure it?

New Member

Re: Need help with installation new 1MFT Wic controller

Or maybe go up to 12.4, if you don't mind running that.

New Member

Re: Need help with installation new 1MFT Wic controller

I will try that tomorrow and see what happens

thanks for the help

168
Views
0
Helpful
12
Replies
CreatePlease to create content