I find myself in uncharted territory here and hope that you can help...
I have a customer that owns a building and rents the individual offices to independent business owners. He has two T1's coming in to the building and feeds two separate circuits. Most all users are on the primary T1 and then a handful of high bandwidth users are on the second circuit.
This is a two story building with the second floor wiring closet above the first floor wiring closet. First story should have 75 offices on the first T1 and 12 on the second. Second floor has 50 offices on the first T1 and 12 on the second. Each office has one connection back to the wiring closet
The problem we are trying to solve:
He has a hodgepodge of hubs and switches in the wiring closet. We have no way of knowing who is using up the bandwidth. We have no way to cap the bandwidth used by one office so often one person starts a huge download that brings the other 100+ people on their circuit to
We are looking for a manageable switch solution that will allow us to
monitor and cap the usage of each individual port. It would be nice
to be able to pull the information up from a graphical web page. The
switches should be able to be connected together. Is it possible for
the switches to be grouped together as one unit between floor?
I'm thinking of the following layout:
First T1 - Three 24 port switches first floor - two 24 port switches second floor
Second T1 - One 24 port switch first floor and one twenty four port switch on the second floor
Can you pleae reccomend a Cisco product that fills the needs (cost is a big issue for us)
Make use of the Cisco Catalyst Switch Solution Finder. This is an easy-to-use tool that can help you identify the right Cisco Catalyst Switch to meet your networking requirements for campus, branch, and data center networks of all sizes.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...