Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need some advice on SPAN fundamental

Hi all,

I need some validation on my config. As can seen from the attached topology, my intention just want to mnitor vlan 1, 25, 51, 250-254, 500 these VLANs.

The monitoring data will pump back to my ISE virtual appliance via port G4/46.

My question

01. My source port is G4/47, this is WLC uplink to core switch, switchport nature is trunk mode, carry all VLAN. Is my below monitor session x filter vlan command not forwarding VLAN 100 monitor data to SPAN desitnation interface?

monitor session 1 source interface Gi4/47

monitor session 1 filter vlan 1 , 25 , 51 , 250 - 254 , 500

monitor session 1 destination interface Gi4/46

02. Can please verify anything wrong on my config. My requirement is not to forward any monitoring data from VLAN 100 to reach ISE monitoring module.

Thanks

Noel

1 REPLY

Need some advice on SPAN fundamental

183
Views
0
Helpful
1
Replies