05-12-2008 07:35 AM - edited 03-05-2019 10:54 PM
All, we've recently purchased a sup-32 module for a 6500. For some reason, they sent us one with CATOS. I need to convert it to IOS. I have the IOS file I need, I just haven't found any good documentation on how to do it. Can you help me out? I should point out that I have a memory card with an IOS on it that I plugged into the sup engine. However when I try to boot from rommon it says "device does not contain a valid magic number".
Solved! Go to Solution.
05-12-2008 09:08 AM
Been there :-)
We used this guide with no problem:
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml
05-12-2008 09:08 AM
Been there :-)
We used this guide with no problem:
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml
05-12-2008 11:07 AM
That's what I was looking for. 5 rating for you! Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide