Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need to do PoE

Hello's,

I have a couple Cisco AP's I'd like to get going with Power over Ethernet.  Is there any way to tell from "show version" if my switch supports this?  If so, what do I need to do to go about enabling?

Cisco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(35)SE5, RELEA

SE SOFTWARE (fc1)

Copyright (c) 1986-2007 by Cisco Systems, Inc.

Compiled Thu 19-Jul-07 20:06 by nachen

Image text-base: 0x00003000, data-base: 0x00D40000

ROM: Bootstrap program is C2960 boot loader

BOOTLDR: C2960 Boot Loader (C2960-HBOOT-M) Version 12.2(25r)SEE1, RELEASE SOFTWA

RE (fc1)

2960G uptime is 26 weeks, 1 day, 12 hours, 38 minutes

System returned to ROM by power-on

System image file is "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.

SE5.bin"

cisco WS-C2960G-24TC-L (PowerPC405) processor (revision E0) with 61440K/4088K by

tes of memory.

Processor board ID FOC1221X0GJ

Last reset from power-on

2 Virtual Ethernet interfaces

24 Gigabit Ethernet interfaces

The password-recovery mechanism is enabled.

64K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address       : 00:21:D7:99:E7:80

Motherboard assembly number     : 73-10015-06

Power supply part number        : 341-0098-02

Motherboard serial number       : FOC12210CEA

Power supply serial number      : DCA1217915B

Model revision number           : E0

Motherboard revision number     : A0

Model number                    : WS-C2960G-24TC-L

System serial number            : FOC1221X0GJ

Top Assembly Part Number        : 800-26673-03

Top Assembly Revision Number    : B0

Version ID                      : V03

CLEI Code Number                : COM3G00BRB

Hardware Board Revision Number  : 0x01

Switch   Ports  Model              SW Version              SW Image

------   -----  -----              ----------              ----------

*    1   24     WS-C2960G-24TC-L   12.2(35)SE5             C2960-LANBASE-M

Configuration register is 0xF

2960G#

Thanks for any help.

1 REPLY
Hall of Fame Super Gold

Re: Need to do PoE

Under "Model Number" your appliance is a WS-C2960G-24TC-L and does not support PoE.  PoE normally have the code "P" after like WS-C2960G-24PC-L.

Just in case, you also verify by using the following commands:

1.  sh inventory - this will give you a brief description of your appliance; and
2.  sh power inline - will tell you if your switch is PoE

424
Views
0
Helpful
1
Replies