Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need to load image on 3750 remotely

I have a 3750 at a remote location. I have it connected to an Avocent console server, so I can access it via the console. It currently has no image on it and only loads to the boot loader.

I know that typically I could load an image through xmodem, but I don't think I have that as an option with the console server.

I have the switch connected to another 3750 with a stack cable. Is there a way that I can push the image through this?

Or does anyone know how I can use xmodem with the Avocent?

Thanks.

Jason

3 REPLIES

Re: Need to load image on 3750 remotely

Jason-

If you ever figure out how to xmodem via the Avocents, please post it. We use them too and I have not figured that out yet. On to your issue. If you type dir all, you should see the file systems for all the switches in the stack. Then copy from one file system to another.

copy flash3:/c3750-ipservicesk9-mz.122-35.SE2.bin flash1:/c3750-ipservicesk9-mz.122-35.SE2.bin

Hope that helps.

New Member

Re: Need to load image on 3750 remotely

Since the bad switch will only load into the boot loader, the good switch in the stack is not seeing it as a member.

Re: Need to load image on 3750 remotely

Yup you're right, sorry about that. Have you tried the auto-upgrade command? Here's a link on it and other troubleshooting tips.

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_example09186a00804799d7.shtml

388
Views
0
Helpful
3
Replies