Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Nesting Macros

Is there a way to call interface level macros from global macros on the 3560 series switches (12.2.44.SE1)?

I have a defined interface level macro that I would like to be able to call from a global macro and apply to a range of interfaces.

Yes, I know that I could easily just apply it from the int range command without a global macro, but this way, I could pre-define the range without worrying that I am affecting a port that requires a different config.

Thanks

261
Views
0
Helpful
0
Replies