Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NetFlow Command Support on C4503

Hi

I am trying to use the following commands on the switch but it is not supported:

ip route-cache flow    

ip flow-export destination

Attached is the output for show version and show module commands from the switch.

I will appreciate support from the cisco community to help me get this fixed.

Thanks

Ibrahim Sayeed

Everyone's tags (5)
9 REPLIES
New Member

NetFlow Command Support on C4503

Is it mandatory to have a NetFlow Service Card installed in the switch to use netflow commands.

NetFlow Command Support on C4503

Hello Ibrahim,

This feature is only supported if you have a netflow services card (WS-F4531). Without this, it won't support. Below is a link which provides this info

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/20ew/configuration/guide/nfswitch.html

&

http://www.solarwinds.com/documentation/Netflow/docs/OrionNetFlowSwitches.pdf

Thanks

Vivek

NetFlow Command Support on C4503

Hi Ibrahim,

All 4500 series switches need a seperate NetFlow service card to be configured to support NetFlow.
For your information, I have a 4507R for one of my customer without this card and unable to configure NetFlow.
So then I suggested to my customer to buy a seperate card to be work NetFlow on this switch. Once I instaleed the card and then only I was able to configure the NetFlow.


Hope the above clear and understand you.
Please rate all the helpfull posts.
Regards,
Naidu.

New Member

NetFlow Command Support on C4503

Thanks Guys. Appreciate ur support. So now once I  get this service card installed I shud b able to configure the netflow commands.

NetFlow Command Support on C4503

Yes you are right. All the netflow based commands will be auto-enabled as soon as you install the service card.

Please close the thread if we have answered your query.

Thanks

Vivek

NetFlow Command Support on C4503

Hi Ibrahim,

Once you inserted the card in slot (host swapable), once the IOS detected the card and sync done, you will be able to find all realted commands.


Hope the above clear and understand you.
Please rate all the helpfull posts.
Regards,
Naidu.

New Member

NetFlow Command Support on C4503

Thanks a lot guys for your support.

R

Ibrahim SAYEED

New Member

NetFlow Command Support on C4503

Hey Guys

Check out this link

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6555/ps6601/ps6965/white_paper_c11-545581.html

Does this mean we can configure the Flexible NetFlow commands without netflow services card (WS-F4531)?

New Member

NetFlow Command Support on C4503

Hi

Check this discussion. Hope it helps anyone looking for a similar answer or going thru same confusion.

https://supportforums.cisco.com/message/3613222#3613222

R

Ibrahim SAYEED

1036
Views
10
Helpful
9
Replies