Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

netflow configuration SUP2T

Hi,

I have problem configuring Netflow on 6500/SUP2T : it seems that standard commands do not exist on that SUP (ex : ip flow xxx).

I tried to configure flexible Netflow too but it applies only to routed interfaces ...

Perhaps the commands have changed for that SUP (as for QOS commands).

I am really new to netflow configuration.

Can anyone help me ?

I need only the very basic commands to configure.

Thanks in advance

Caroline         

Everyone's tags (3)
3 REPLIES
VIP Super Bronze

netflow configuration SUP2T

Hi,

Sup 2T has actualy more Netflow capabilities than the older sups.

Here is doc with config example:

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/white_paper_c11-652021.html

HTH

New Member

netflow configuration SUP2T

Hi Reza,

Actually, I have configured flexible netflow already but no way to apply the "ip flow monitor" configured to the interface if in switchport state, I don't know why ...

With routed interfaces (no switchport), the command passes.

Unfortunately, I have only switchport interfaces configured (no routing on the 6500).

Any idea ?

Anyway, I will try to redo the config, based on the documentation you provided.

Thanks

Silver

Re: netflow configuration SUP2T

Hi Caroline,

Netflow does not work on IPBase in 12.2(50)SY versions. You either need IPServices or higher or run 15.0(1)SY release or later.

Best regards,

Andras

4423
Views
5
Helpful
3
Replies