Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Netflow in Cisco 6513 with Sup 2T

After installing Cisco 6513 with 2T sup engine, we have configured netflow as below. But we did not received any data in Netflow server (CA NetQoS).


flow record NFRec
match ipv4 tos
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match ipv6 traffic-class
match ipv6 protocol
match transport source-port
match transport destination-port
collect counter bytes
collect counter packets
collect timestamp sys-uptime first
collect timestamp sys-uptime last


flow exporter NFExp
destination x.x.x.x
source Loopback0
option exporter-stats timeout 20

flow monitor NFMon
record NFRec
exporter NFExp

interface Vlan x
description xxxx
ip address x.x.x.x x.x.x.x
ip flow monitor NFMon input
ip flow monitor NFMon output

We have alos raised a query with OEM CA for netflow, and as per them

These are the minimum required fields by RA using v5 flows for data to appear in ReporterAnalyzer:

1 - IN_BYTES

4 - PROTOCOL

7 - L4_SRC_PORT

8 - IPV4_SRC_ADDR

10 - INPUT_SNMP

11 - L4_DST_PORT

12 - IPV4_DST_ADDR

14 - OUTPUT_SNMP

You can take this issue further with vendor

In Wireshark, we checked and found that INPUT_SNMP and OUTPUT_SNMP parameters are not coming.

Hi,

It is resolved now. We just need to add below two parameters in Flow Record.

collect interface input snmp
collect interface output snmp

Thanks...

collect interface input snmp
collect interface output snmp
165
Views
0
Helpful
0
Replies