Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Netflow-Lite on the 2960-x switch

Hello,

I'm trying to take a look at the Netflow feature of the new 2960-x switch and I'm following the commands on the below URL but I'm getting stuck as my source to our LAN is an etherchannel and it won't let me use a port-channel as a source, shall I just use of the gigabit ports that are part of the etherchannel?

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps12995/solution_overview_c22-728776.html

Thanks

1 REPLY
Green

Netflow-Lite on the 2960-x switch

Andy,

Looking at a config guide for the 2960x

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960x/software/15.0_2_EX/fnf/configuration_guide/b_fnf_152ex_2960-x_cg_chapter_010.html

Prerequisites for NetFlow Lite

The following are prerequisites for your NetFlow Lite configuration:

  • NetFlow Lite is only supported on switches running the LAN Base image. Switches running the LAN Lite image do not support NetFlow Lite.
  • Two targets for attaching a NetFlow Lite monitor are supported:
    • Port—Monitor attachment is only supported on physical interfaces and not on logical interfaces, such as EtherChannels.

    • VLAN—Monitor attachment is supported on VLAN interfaces only (SVI) and not on a Layer 2 VLAN.

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
312
Views
0
Helpful
1
Replies
CreatePlease login to create content