Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Netflow on 6509E with sup2T-10G

Hi guys,

I'm trying to enable netflow on my new 6509E with the sup2t, i put the follows commands:

sw(config)#mls netflow

sw(config)# mls flow ip full (don't support the command, it show me an error)

sw(config)# ip flow ingress layer2-switched vlan 500

int vlan 500

ip flow ingress

int gx/x

no switchport

ip add x.x.x.x

ip flow ingress

but when i write the command "sh mls ip" it doesn't show anything....mmmmm....is it missing something in the configuration???? what are the correct steps for enable netflow????

The IOS is

Image Version = Cisco IOS Software, s2t54 Software (s2t54-IPBASEK9-M), Version 15.0(1)SY

these are part of the show module command:

Mod  Sub-Module                  Model             

---- --------------------------- ------------------

  1  Distributed Forwarding Card WS-F6K-DFC4-A     

  2  Distributed Forwarding Card WS-F6K-DFC4-A     

  3  Distributed Forwarding Card WS-F6K-DFC4-A     

  5  Policy Feature Card 4       VS-F6K-PFC4       

  5  CPU Daughterboard           VS-F6K-MSFC5      

  6  Policy Feature Card 4       VS-F6K-PFC4       

  6  CPU Daughterboard           VS-F6K-MSFC5    

Thanks guys for your help

Best regards.

  • LAN Switching and Routing
660
Views
0
Helpful
0
Replies
This widget could not be displayed.