Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

netflow on port-channel interface not work

I have a layer 3 switch, gi1/1 & gi2/1 is port-channel and the channel port is a routed port. I have configured "ip flow ingress" for interface port-channel1, gi1/1 & gi2/1. But it seems that the netflow doesn't work. Below is the inteface config. Is there any config mistake.

int port-channel1

ip address x.x.x.x x.x.x.x

ip flow ingress

int g1/1

channel-group 1 mode on

ip flow ingress

int g2/1

channel-group 1 mode on

ip flow ingress

Thanks.

3 REPLIES
New Member

Re: netflow on port-channel interface not work

Follwoing commands used to configure Netflow for the CatOS.

set mls flow , set mls nde 9996, set mls nde version

set mls nde enable.

Bronze

Re: netflow on port-channel interface not work

what kind of cisco switch/router is this???

That makes a difference.

New Member

Re: netflow on port-channel interface not work

i am using catalyst 6509 with native ios.

Thanks.

1642
Views
0
Helpful
3
Replies