Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Network Analyse Module NAM 2 in Cat 6500/IOS

Hi,

I have installed a Network Analysis Module (NAM2) in a catalyst 6500.

After this I saw with "sh monitor session" a session 1 / Type Service Modul Session". Depending on this I am only able to configure two more sessions,

when I want to configure a third session for capturing traffic on the NAM I got an error message, that this is not possible. The documentation means that I can configure two span ports for traffic capturing, but depending on the first automatically created session it does not work, because all together I have three sessions. Has anyone an idea, how I can get my two session for NAM capturing and for what is the first session ?

Regards Mike

3 REPLIES
New Member

Re: Network Analyse Module NAM 2 in Cat 6500/IOS

You can have more destinations and sources per session.

CR10#sho monitor sess 1

Session 1

---------

Type : Local Session

Source VLANs :

Both : 298

Destination Ports : Gi3/13,Gi3/16,analysis-module 9 data-port 1

CR10#sho monitor sess 2

Session 2

---------

Type : Local Session

Source VLANs :

Both : 41,300,449,651-652,701-702,708,801-802

Destination Ports : analysis-module 9 data-port 2

Hope this helps

Mats

New Member

Re: Network Analyse Module NAM 2 in Cat 6500/IOS

Hi Mats,

thank you for your answer. I habe tried your suggestion:

sh monitor

Session 1

---------

Type : Service Module Session

Modules allowed : 1-6

Modules active : 6

BPDUs allowed : Yes

Session 66

----------

Type : Local Session

Source Ports :

Both : Gi5/1

Destination Ports : Fa3/48

RZR-E1(config)#monitor session 1 source vlan 241 both

% Session 1 used by service module

Mike

New Member

Re: Network Analyse Module NAM 2 in Cat 6500/IOS

I have no idea about service module session!

I'm running 12.2(18)SXD7b. I think I had a session 1 when I installed the NAM in slot 9.

Mats

131
Views
0
Helpful
3
Replies
CreatePlease to create content