The reason these have been put in is becasue randomly the network runs very slow. I was wondering if there where any tools our there that would let me check the Cisco switches for any ports sending excessive packets / drops etc.
If you decide to go with something that does support snmp, you could use something like Solarwinds Orion or MRTG to be able to poll interfaces. I don't have experience with these switches, but you may have a web interface that you can get into to view port statistics as well.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...