I have a 2950 and 3550 switch network, i have a lot of VLANs in our network, i am facing a problem that some time our ssh session hang with different Linux server. I face this problem specially when I i use two network card one is Real IP and second is Local Network Ip Card.
since you say that you have two NIC's, make sure that you have not set 2 Gateway for 2 NIC's in the PC, 1 NIC should have the default gateway & other should have the static route, please lemme know about this.
I am not really clear on your initial problem description: do you have a PC with two NICs, and do you want to establish an SSH connection to a LINUX server ? Or do you have a LINUX server with two NICs, and do you want to establish an SSH connection to another machine ?
You might want to turn on SSH debugging (debug ip ssh) to see if that reveals a clue...
No i have a Window based system, i remotly access a Linux server through SSH client(Putty). Seesion Hang during SSH connection, and two NIC card are installed on a Window based system through which i try to connect to Linux Server.
yeah in that windows PC, let one NIC which is pointing towards internet have the the default gateway IP address & the other NIC pointing towards the LAN can have the static route. juz go to command prompt & type...
eg. in windows "route add 192.168.1.0 -netmask 255.255.255.0 10.1.1.1 -p "
here -p represents the permananet entry in the windows even if you restart the pc.
i think this could cause your ssh to get hang as the windows will get confussed having 2 gateways.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...