Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Network Routing Issue on ISR

Hello Community

Can someone please take a look at the attached configuration and let me know why I can't ping the dialer interface's own ip address?

Cheers

Carlton

1 REPLY
New Member

Network Routing Issue on ISR

Experts,


I should point out the virtual-access2 keeps on bouncing


Sep 17 08:37:44.047: %LINEPROTO-5-UPDOWN: Line protocol on Interface Virtual-Access2, changed state to up


UK01135-RDM01-ColmoreRd#sh

ow interfaces dialer 1

Dialer1 is up, line protocol is up (spoofing)

  Hardware is Unknown

  Internet address is 80.229.77.203/29

  MTU 1500 bytes, BW 56 Kbit/sec, DLY 20000 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation PPP, LCP Closed, loopback not set

  Keepalive set (10 sec)

  DTR is pulsed for 1 seconds on reset

  Interface is bound to Vi2

  Last input never, output never, output hang never

  Last clearing of "show interface" counters 17:37:42

  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: fifo

  Output queue: 0/40 (size/max)

  5 minute input rate 0 bits/sec, 0 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     12346 packets input, 745390 bytes

     17286 packets output, 243231 bytes

Bound to:

Virtual-Access2 is up, line protocol is up

  Hardware is Virtual Access interface

  MTU 1500 bytes, BW 1064 Kbit/sec, DLY 20000 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation PPP, LCP Open

  Stopped: IPCP

  PPPoATM vaccess, cloned from Dialer1

  Vaccess status 0x44

  Bound to ATM0/0/0 VCD: 1, VPI: 0, VCI: 38, loopback not set

  Keepalive set (10 sec)

  DTR is pulsed for 5 seconds on reset

  Interface is bound to Di1 (Encapsulation PPP)

  Last input 00:00:00, output never, output hang never

  Last clearing of "show interface" counters 17:36:24

  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: fifo

  Output queue: 0/40 (size/max)

  5 minute input rate 0 bits/sec, 0 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     17972 packets input, 1082962 bytes, 0 no buffer

     Received 0 broadcasts (0 IP multicasts)

     0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

     17483 packets output, 246037 bytes, 0 underruns

     0 output errors, 0 collisions, 0 interface resets

     0 unknown protocol drops

     0 output buffer failures, 0 output buffers swapped out

     0 carrier transitions

UK01135-RDM01-ColmoreRd#

129
Views
0
Helpful
1
Replies