I swear I am slowly but surely getting better at this. But I have another basic question. I have a new 3mbps circiut that goes directly to the internet. So far, I have the router setup and I am using a cross connect cable to my laptop to use this circuit. I want to set this up for my business in the following way:
internet --> router -->firewall -->switch --> end users (192.168.169.0)
i am confused on having the inside users going through the firewall and router out to the internet. we have done away with all of our nvpn circuits and will build tunnels to connect to other offices. at what point do i translate the inside ip address to the public ip whcih then goes to the circuit id?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...