Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

new 10Gb uplink running at snail pace.

just installed our first 10Gb uplink..2960s > 4510R with SUP7. link is running really slow. Users are unable to load data from remote databases on the LAN. We are getting a lot of "errors in". Is on new new SM Fiber install. Error In is showing on 4510 and 2960s sides of link.

Made no special configurations for 10Gb link. Same as our normal 1Gb uplinks. Any thoughts or configuration solutions? One thought was clocking. Never had to do this on a switched link.

Sent from Cisco Technical Support iPad App

2 REPLIES
New Member

Re: new 10Gb uplink running at snail pace.

Switched shouldnt need any special config ( clocking etc )

Few things id check.

- Is the fiber clean? can you try a new one?

- MTU? What are they set to? do you have jumbo enabled? Are they the same at both ends?

- What "errors" are they on the interface?

All I can think of is either dirty fiber or bad mtu or maybe a bad transeiver? Do you have a spare to try? different port?

-Graham
Please note: My comments are simply suggestions. I cannot be held liable for any loss of data, life or marbles due to following my instructions.

Got a website? Need some live chat software?

Hall of Fame Super Gold

new 10Gb uplink running at snail pace.

Can you please post the output to the following commands on the 2960S:

1.  sh version;

2.  sh interface Ten ;

3.  sh controller e Ten

224
Views
0
Helpful
2
Replies
CreatePlease to create content