cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2843
Views
0
Helpful
19
Replies

new blade not recognized...

davisr651
Level 1
Level 1

I recently added 2 more 48-port  gigbit blades in my Cisco 4510R switch chassis, which is now maxed.. the blade in slot 8 is recognized no problem, but the blade in slot 9 is not....

to rule out the blade being the issue, i removed the blade from slot 8  where it was working, and put in slot 9, and still did not work...

any ideas?

thanks

rob davis

19 Replies 19

sh mode results....

so,  i can t put the ... WS-4548--GB-RJ45 in slot 10? 

davisr651 wrote:

sh mode results....

so,  i can t put the ... WS-4548--GB-RJ45 in slot 10? 

Unfortunately no you can't. As per previous post you can only put those linecards mentioned. If you had a sup V-10GE then you would be able to use that linecard in slot 10.

Jon

What is the differernce between a v-10  and v-10ge?

Rob

The sup V-10GE has 2 x 10Gbp uplinks on the supervisor. It also increases the available switching fabric which is why you can run all linecards in slot 10.

Jon

Thank you for your  expertise...

have a good weekend...

rob davis

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: