Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

New CISCO2921/K9 - no acl hit counts

I just installed a new cisco 2921 router on a remote MPLS location.  I applied an acl to the wan port of the 2921 and I am not getting any "hit counts" on the acl even though the last statement on the acl is "any any".  Is there something I need to activate on the router?

interface GigabitEthernet0/0

ip address 10.110.174.21 255.255.255.0

ip access-group test in

ip accounting output-packets

duplex auto

speed auto

ip access-list extended test

permit ip 10.241.50.0 0.0.0.255 host 10.110.174.20

permit ip 10.241.50.0 0.0.0.255 host 10.110.174.21

permit ip any any

Extended IP access list test

    10 permit ip 10.241.50.0 0.0.0.255 host 10.110.174.20

    11 permit ip 10.241.50.0 0.0.0.255 host 10.110.174.21

    20 permit ip any any

2 REPLIES

Re: New CISCO2921/K9 - no acl hit counts

Hi,

Kindly add the 'log' keyword at the end of the ACE.

20 permit ip any any log

Sent from Cisco Technical Support iPad App

New Member

Re: New CISCO2921/K9 - no acl hit counts

Dear Mark ,

just add in the ACL and apply it

20 permit ip any any log

Rate it use full post

145
Views
1
Helpful
2
Replies
CreatePlease login to create content