Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

New switch IOS/Config upgrade issues

This is a very basic question.

I have configured a 3560, vlan 1 with an IP address of 10.10.10.1, set fa0/1 to access vlan 1

I have set my laptop up with IP address 10.10.10.10, default gateway 10.10.10.1.

From the laptop I can PING and Telnet into the switch, however, from the switch I cannot PING or open up a TFTP session with the TFP server running on the laptop

I configured fa0/1 as:

switchport

switchport mode access

switchport access vlan 1

no shut

However, if I do a show run, there is only one line listed:

Interface Fa0/1

switchport mode access

Thanks

2 REPLIES
Cisco Employee

Re: New switch IOS/Config upgrade issues

Hi,

The switchports are by default in vlan 1, so the command "switchport access vlan 1" is/was already in there, hence you don't see the command when you do a show run on the interface.

Check the firewall on the PC. I am pretty sure its the Windows firewall or other firewall blocking it. Disable that and it should start working.

JayaKrishna

New Member

Re: New switch IOS/Config upgrade issues

Fixed thanks...  Firewall

161
Views
5
Helpful
2
Replies
CreatePlease login to create content