Newbie question - Physical switch / network jack identification
We are in a bot of a bind and I was hoping someone could point me in the right direction, if this is even possible.
We need to be able to identify the Network Jack when a device is connected to it (ultimately identifying the location where the device was connected at that time). As the devices and locations may change I was hoping it would be possible to set the switch up to forward traffic from a particular port on the switch (which wil corelate to a port on a wal in a specific room) to a specific IP and port on a network server?
Re: Newbie question - Physical switch / network jack identificat
I don't know of a way to do that . The only thing I can think of is to make sure you have snmp trap link status on all the switchports . Then have someone in the switch looking at it with term mon on and have the person plug the cable in a out a few times and you should see that link going up and down .
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...