Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Nexus 2248TP port speed and duplexing

Hello Forum Team!

   In order to configure the port speed and duplexing (change to 100Mbps/Full-duplex from auto mode) on a Nexus 2248TP interface, does the port needs to be down,.i.e, no link?

 

Thanks in advanced for your support!

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

No, you can do it anytime.

No, you can do it anytime.

3 REPLIES
Community Member

No, you can do it anytime.

No, you can do it anytime.

Community Member

Hello and thanks for reply;  

Hello and thanks for reply;

      I was trying to configure port speed and duplexing on a 2148. This FEX model only works at 1000Mbps as I later found out on the documentation.

Thanks again for your support.

 

Community Member

Re: Hello and thanks for reply;

And about the 2248TP, does it works at 100Mpbs? And is it able to auto-negotiation at 100Mpbs?

171
Views
0
Helpful
3
Replies
CreatePlease to create content