Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

NEXUS 3548 connected to WAN DEVICE (Fortigate)

                   Hei guys, a quick help.

I configured my nexus 3548 and connected to outside device which is a Fortigate. For some reason the port in switch is not coming up. I changed the speed to 1gbps. I connected laptop in switch and Fortigate seperately and found ports coming up (so not port issue).

Sh interface brief gives me reply, link not connected. Anyone faced similar issues

2 REPLIES
Cisco Employee

NEXUS 3548 connected to WAN DEVICE (Fortigate)

Hi Faisal,

What type of cable are you using?

What is the transceiver type?

Can you share the below command outputs?

show logging

show hardware int neutron-usd-uc retimer-param front-port eth x/x

show hardware int neutron-usd-uc retimer-param front-port

Show hard int mtc-usd port-status front-port

Show interface X

Show interface x transceiver detail

Show run interface X

Show run interface X all

Show sys int ethpm info interface X

Show sys int ethpm event interface X

Thanks,

Richard.

New Member

NEXUS 3548 connected to WAN DEVICE (Fortigate)

Well, "no negociate auto" ?

548
Views
0
Helpful
2
Replies
CreatePlease to create content