First time trying to configure these . Trying to get the peer links to work and have them in interfaces E1/1-4 . When i do a show int status it looks like this and says sfp invalid. I see this on both sides . Anyone ever see this ? These same model gbics work fine attached to a FEX on these boxes. Thanks for any help . A firstimer on the Nexus gear.
Eth1/1 vpc peer link to T sfpInvali trunk full 10G Fabric Exte
Eth1/2 vpc peer link to T sfpInvali trunk full 10G Fabric Exte
Eth1/3 vpc peer link to T sfpInvali trunk full 10G Fabric Exte
Eth1/4 vpc peer link to T sfpInvali trunk full 10G Fabric Exte
Gbic in ports are this.
transceiver is present
type is Fabric Extender Transceiver
name is CISCO-FINISAR
part number is FTLX8570D3BCL-C1
revision is A
serial number is FNS16062QU8
nominal bitrate is 10300 MBit/sec
Link length supported for 50/125um OM3 fiber is 100 m
Link length supported for 62.5/125um fiber is 10 m
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...