Being the first time I have worked on these is all you have to do to manage the box is like any other switch where you just create a SVI with an address and add the default static pointing to the gateway ? These are a little different that's for sure.
Yeah we are just seeing some strange stuff , we have 2 nexus 5000's connected via the peer links. Have an SVi vlan 712 on both configured with different addresses in the same range going to a couple of firewalls which is the gateway for that Network management space. For some reason we can only get to one of the 5000's at a time and can't figure out why at this point . 5000's are peered ok from what i can tell and all fex's look ok.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...