Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Nexus 5000 port channels

Hi,

 

I CONFIGURED A PORT CHANNEL FOR ACCESS PORT AS BELOW ON n5K AND ASSIGNED  A STATIC IP ADDRESS TO THE SERVER.

FROM THE SERVER I TRIED TO PING VLAN 390 GATEWAY...I AM UNABLE TO PING IT....CAN SOME ONE HELP ME OUT ? IS BELOW CONFIG IS CORRECT ... DO I NEED TO CONFIGURE "CHANNEL-GROUP 63 MODE ACTIVE " UNDER THE E110/1/33 ????

 

interface port-channel63
  description SERVER
  switchport access vlan 390

interface Ethernet110/1/33
  description SERVER-A
  switchport access vlan 390
  spanning-tree port type edge
  no snmp trap link-status
  channel-group 63

  • LAN Switching and Routing
1 REPLY
New Member

vishwanathgautham,Not sure

vishwanathgautham,

Not sure why you are configuring port-channel down to a single server-access port.

Then if you want to configure port--channel you will need to configure similar configuration on the server side as well, you may want to "team-of NIC" (with correct configuration for).

Here is the link that may be useful for vPC configuration.

http://www.cisco.com/c/en/us/products/collateral/switches/nexus-5000-series-switches/configuration_guide_c07-543563.html

HTH.....Thanks!

Subodh

 

52
Views
0
Helpful
1
Replies
This widget could not be displayed.