According to release notes, this is available in v5.1.3-n1.1. I am running 5.1.3-n1.1a
According to the security guide, all you should have to do is config t, then control-plane, but I do not have that option:
nx5k-2(config)# c?
callhome Enter the callhome configuration mode
cdp Configure CDP parameters
cfs CFS configuration commands
class-map Configure a class map
cli Configure CLI commands
clock Manage the system clock
nx5k-2(config)#
so my question is, is CoPP only available with the 5500s?
thanks -chris