Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

nexus 5020 mac-address-table

when i try to enter more than one interface

like the below I get 'invalid number of interfaces specified'

mac-address-table static  0000.0000.0000 vlan 10 interface eth1/17 eth1/21 eth1/25

1 REPLY

Re: nexus 5020 mac-address-table

Hi

Im not sure about the particular platform of Nexus, but generally why would you need one MAC address to be assigned to more than one port ? I did read somewhere that you can add more interfaces with this command (on general L2/L3 switches), but you need to more interfaces by repeating the command.. try it one by one... but still not sure of your design requirement.

Hope this helps.. all the best..

Raj

394
Views
0
Helpful
1
Replies