I'm facing some doubts regarding a project I'm responsible.
We have 4 nexus 5596UP and 4 FEX. Each pair of Nexus are located in different datacenter. Each pair of Nexus in the same datacenter is connected to 2 FEX in a dual-homed way. Each Nexus in Datacenter1 is connected to a single Nexus in datacenter2.
All 4 Nexus have layer3 module and should run layer3 (interface VLAN/HSRP). Probably no licenses to fabricpath (enhanced license)
- What's the best way to configure interdatacenters connection?...VPC or FabricPath?
- How can I configure layer 3 FHRP (HSRP/GLBP) as we have 4 Nexus?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...