Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Nexus 5548 rate limit

Hello,

I am trying to setup a rate limit on fex ports (modl is N2K-C2248TP-1GE ) of a 5548UP (non L3)  -  Software version is : version 6.0(2)N2(2)

I have tried the following setup without success  :

ip access-list ACL_CUST

  10 permit ip 10.100.100.1/32 10.100.100.2/32

  20 permit ip 10.100.100.2/32 10.100.100.1/32

class-map type qos match-all CMQOS_CUST

  match access-group name ACL_CUST

policy-map type qos PMQOS_CUST

class CMQOS_CUST

    police cir percent 1 bc 200 ms conform transmit violate drop

interface Ethernet161/1/11 - 12

  service-policy type qos input PMQOS_CUST

And also tried to use this confioguration :

class-map type qos match-all CMQOS_LIMIT_BP_CUST

  match cos 0-7

policy-map type qos PMQOS_LIMIT_BP_CUST

  class CMQOS_LIMIT_BP_CUST

    police cir percent 1 bc 200 ms conform transmit violate drop

interface Ethernet161/1/11 - 12

  service-policy type qos input PMQOS_LIMIT_BP_CUST

The problem is that the bandwith restriction (1 percent of 1Gbit/s shoud be 10Mbit/s) is not working and apparently no restriction is applied

If someone could help me to resolve this issue it would be greatly appreciated

I do have followed this guide

http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/qos/503_n1_1/cisco_nexus_5000_qos_config_gd_503_chapter3.html

Thanks !

Everyone's tags (3)
609
Views
0
Helpful
0
Replies
CreatePlease login to create content