Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

nexus 5548up loader> how to resolve this issue?

loader> dir

bootflash:

  lost+found

  n5000-uk9-kickstart.5.1.3.N1.1a.bin

  n5000-uk9.5.1.3.N1.1a.bin

  mts.log

  vdc_2

  vdc_3

  vdc_4

  vlan.dat

  MDS201309012310597480.lic

loader> boot n5000-uk9-kickstart.5.1.3.N1.1a.bin

Cisco Nexus Operating System (NX-OS) Software

TAC support: http://www.cisco.com/tac

Copyright (c) 2002-2012, Cisco Systems, Inc. All rights reserved.

The copyrights to certain works contained in this software are

owned by other third parties and used and distributed under

license. Certain components of this software are licensed under

the GNU General Public License (GPL) version 2.0 or the GNU

Lesser General Public License (LGPL) Version 2.1. A copy of each

such license is available at

http://www.opensource.org/licenses/gpl-2.0.php and

http://www.opensource.org/licenses/lgpl-2.1.php

switch(boot)#

How to recover from the mode

after reload the switch its going back to loader>

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: nexus 5548up loader> how to resolve this issue?

Rupesh,

I just finished from the same situation and resolved it

Please follow th document mentioned below;

http://www.cisco.com/en/US/docs/switches/datacenter/sw/password_recovery/nx_os_pw.html

Step 14 Boot the Cisco NX-OS kickstart image on the standby supervisor module, if necessary.

In the following example, the kickstart image filename is nx-os_kickstart.bin:

loader# boot bootflash:nx-os_kickstart.bin

Step 15 Load the Cisco NX-OS system software on the standby supervisor module, if necessary.

In the following example, the system image filename is nx-os.bin:

switch(boot)# load bootflash:nx-os.bin

Step 16 Save the configuration.

HTH

Regards

Inayath

***Plz  don't forget to rate this post if this info is helpfull***************

2 REPLIES
Cisco Employee

Re: nexus 5548up loader> how to resolve this issue?

Rupesh,

I just finished from the same situation and resolved it

Please follow th document mentioned below;

http://www.cisco.com/en/US/docs/switches/datacenter/sw/password_recovery/nx_os_pw.html

Step 14 Boot the Cisco NX-OS kickstart image on the standby supervisor module, if necessary.

In the following example, the kickstart image filename is nx-os_kickstart.bin:

loader# boot bootflash:nx-os_kickstart.bin

Step 15 Load the Cisco NX-OS system software on the standby supervisor module, if necessary.

In the following example, the system image filename is nx-os.bin:

switch(boot)# load bootflash:nx-os.bin

Step 16 Save the configuration.

HTH

Regards

Inayath

***Plz  don't forget to rate this post if this info is helpfull***************

Hall of Fame Super Silver

nexus 5548up loader> how to resolve this issue?

Start with:

boot n5000-uk9-kickstart.5.1.3.N1.1a.bin

After that completes:

load n5000-uk9.5.1.3.N1.1a.bin

414
Views
0
Helpful
2
Replies
CreatePlease to create content