We have a 5548UP connected to a 2248 via a 10Gb cable. I've enabled interface-vlan, fex on top of whatever comes default out of the box. I've also installed the L3 daughter card and installed the license for Layer 3.
On the 5548, I've created a few vlans and gave the vlan ip addresses.
vlan 10 10.10.10.1/24
vlan 20 10.10.20.1/24
vlan 30 10.10.30.1/24
On one of the ports off the 2248, I configured it as switchport access vlan 10 connected to a 2911 with an interface ip address 10.10.10.9/24
I have another port off the 2248 configured as switchport access vlan 20 with a device connected to it with an ip address of 10.10.20.10/24
There is a default route on the 5548 with 10.10.10.9 as the default gateway going to the 2911.
From the 5548 I can ping the vlan interfaces of all the vlans that I've created and all the devices connected to the 2248. I can also ping the interface on the 2911 (10.10.10.9) and all the networks beyond the 2911 sourcing from any vlan interface. However, all the devices off each of the vlans can not ping past its vlan interface.
Any help would be greatly appreciated.
BIOS: version 3.5.0
loader: version N/A
kickstart: version 5.1(3)N1(1a)
system: version 5.1(3)N1(1a)
power-seq: Module 1: version v1.0
Module 3: version v5.0
uC: version v126.96.36.199
SFP uC: Module 1: v188.8.131.52
BIOS compile time: 02/03/2011
kickstart image file is: bootflash:///n5000-uk9-kickstart.5.1.3.N1.1a.bin
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...