Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Nexus 5596 not displaying vlans

I'm wondering if anyone has ever seen this before. On a pair of Nexus 5596 with layer 3 module, when you do 'sh run', the created vlans are NOT displayed. (There are ~50)

When you do 'sh vlan', all vlans are displayed correctly.

Any ideas?

1 REPLY
Purple

   Is the vtp  mode set as

   Is the vtp  mode set as transparent ?  If not it's like IOS it will not show in the config . Probably set as server or client. That is normal behavior if they are set as anything other than transparent mode.

22
Views
0
Helpful
1
Replies
CreatePlease to create content