Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Nexus 5596UP

With this device and the layer 3 engine, does this allow all ports on 2248 FEX's to be put into layer 3 mode?

2 REPLIES
VIP Super Bronze

Nexus 5596UP

Beginning with Cisco Release 5.2(1), you can  configure a Fabric Extender (FEX) port as a Layer 3 interface for host  connectivity, but not for routing

more info:

http://www.cisco.com/en/US/docs/switches/datacenter/sw/5_x/nx-os/interfaces/configuration/guide/if_layer3int.html#wp1304680

HTH

New Member

Nexus 5596UP

I don't understand, why would you configure a port for layer 3 and not be able to route? Thats what layer 3 is....routing...

329
Views
0
Helpful
2
Replies