I have a setup as below. The server is of a HP blade enclosure. Both the blade switch are connected to two different 2Ks with port-channel.( I have not shown that part in the drawing. When i tried to ping from one of the Blade server from the enclosure to the gateway which is available in VSS the response time is different when the server has been configured with/without NIC teaming. With teaming the performance is better tha without teaming. when it is not teamed the ping response time is not consistent. But when it is teamed the performance is consistent & better than our traditiona switch setup.
Have anybody noticed this behaviour pls share if any improvement can be done. I dont see any spanning tree issues here as I have taken care of spanning tree parameters.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...