Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Nexus 7000 COPP Profile

Hello

When I try to change de copp profile I get this error:

NEXUS(config)# copp profile moderate

ERROR: Entry not found in copp database

The active profile is strict. We have 4 Nexus 7000 and only one of the allows me to change that profile.

Running "show runn copp all" command on the 4 Nexus 7000 shows the same information

Everyone's tags (2)
4 REPLIES
Cisco Employee

Nexus 7000 COPP Profile

Hi,

Which version of NX-OS are you running?

Kind Regards,
Ivan

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
New Member

Nexus 7000 COPP Profile

Hi

I'ts

version 6.0(3)

Thanks

Cisco Employee

Nexus 7000 COPP Profile

Hi,

It seems to be internal database issue, described in CSCtw77593.

Conditions:

    The issue happens when a reload based upgrade is performed.

Workarounds #1 is:

1. Reload the switch with NX-OS version where the CoPP profile was last changed/applied (downgrade NX-OS).

2. Remove the current CoPP profile.

3. Upgrade the switch to the newer version and apply the new CoPP profile or CoPP policy.

Workaround #2 is:

1. Save copy of the config to bootflash.

2. Erase the startup config.

3. Reload the switch and copy the config back to switch.

4. Apply the Copp config.

Kind Regards,
Ivan

**Please grade this post if you find it useful.

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
New Member

Re: Nexus 7000 COPP Profile

Hi,

We found this method which is much easier to implement. (Thanks Fai)

7K01# sh run copp

!Command: show running-config copp

!Time: Wed Aug  8 16:49:38 2012

version 6.0(3)

copp profile strict

7K01# conf t

Enter configuration commands, one per line.  End with CNTL/Z.

7K01(config)# copp profile moderate

ERROR: Entry not found in copp database

7K01(config)# no copp profile

7K01(config)# 2012 Aug  8 16:49:54 7K01 %$ VDC-1 %$ %COPP-2-COPP_NO_POLICY: Control-plane is unprotected.

7K01(config)# copp profile moderate

7K01(config)# 2012 Aug  8 16:50:08 7K01 %$ VDC-1 %$ %COPP-2-COPP_POLICY: Control-Plane is protected with policy copp-system-p-policy-moderate.

7K01(config)# sh run copp

!Command: show running-config copp

!Time: Wed Aug  8 16:50:19 2012

version 6.0(3)

copp profile moderate

Message was edited by: Nadun Bandara

1543
Views
0
Helpful
4
Replies
CreatePlease to create content