Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NEXUS 7000 COS marking on trunk port

I am looking for a simple solution to mark traffic coming from a trunk/port-channel with a cos value of 3 I cannot seem to find a document to explain this to me.

Everyone's tags (1)
1 REPLY
Hall of Fame Super Blue

NEXUS 7000 COS marking on trunk port

Jerry

Which version of code are you running ?

I am not familiar with Nexus switches but i have just checked the config guides and there are limitations with CoS marking eg.

v4.x code only allows marking CoS on egress ports (so no use to you)

v5.x and 6.x code do allow ingress marking but only if there are no set commands for the same packet on egress.

So which version are you running ?

Jon

128
Views
0
Helpful
1
Replies
CreatePlease login to create content