Just received and installed 2 Nexus 7010, they booted up just fine with kickstart and system 4.1.4, everything was working just fine at this point. Due to a couple of bugs that could affect the business we upgraded them to 4.2 (3) and a funny thing happened with one of them after the upgrade, after booting up I made sure both sups and modules were working fine as well as supervisor redundancy however in the fron panel there are several leds to show the status of PSU, SUP, IOM, etc and just realized that even though the device is working fine the SUP led is off (not red, amber or green).
Has this happened to any of you and if so mind giving me some advice?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...