We are on NxOS v 6.1.1 on a 7009 with a v1 controller. I see that 6.2.2 is available. Does this version support vPCs to N2248TPs as active/standby and/or active/active?
Does it support pre-provisioning?
We do not need to support vPCs to servers since we use load balancers and clusters.
Currently we have half of our 2Ks active on each 7K, but the FEX uplinks from all 2Ks go to both 7Ks. A failure of a 7K would mean a manual switchover through software by provisioning and configuring the 2Ks on the remaining 7K.
Is there a better way to get redundancy? We have good hardware redundancy since we have dual power, controllers and 48 port modules on each 7K. I am on the fence about adding the complexity to our cores to support vPC since it involves re-defining the link between the 7Ks and there seems to be a lot of caveats and limitations to vPCs.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...