Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Nexus 7000 vrf design question

All,

I hope you are well and hope you can assist

We have a requirement where we have a number of Concession where we need to add them to a VRF.to avoid ACLs / the use of the global ruting table  (L3 segregation)

In the drawing below the black line are the global routing table we have put in another physical fibre between the switches and are using  sub interfaces to allow multiple vrfs over the new physical interface in dotted blue lines, in our example below, L3 vlan 20 on the N7K CCC (left) is in VRF test and L3 vlan 20 on the N7K CCC (right) is also in vlan 20 vlan 20 is also allowed over the VPC peer link.

Question below

Is the below a valid design adn scalable moving forward?

we have seperate physical interfaces for the VRF except for the VPC peer link (L2) the vlans (20) in the vrf will be allowed over the VPC peer link  (L2) and the VRF vlan 20 will form OSPF adjancey between each other over the VPC peer link can that cause any issues  ?   (We will be running ospf with in the VRF)  all blue dotted line will also form ospf adjanceys between each other over the new physical fibres put in place

 

Any advice is Soo much appreciated

 

 

Thanks,

 

Zee

 

 

  • LAN Switching and Routing
2 REPLIES
VIP Super Bronze

Hi,There is no drawing

Hi,

There is no drawing attached.

New Member

Please find network diagram

Please find network diagram attached  upload with the original post.

112
Views
0
Helpful
2
Replies
This widget could not be displayed.