Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Nexus 7010 module Failure

I'm currently getting a Nexus hardware failure at present.

switch %MODULE-2-MOD_DIAG_FAIL: Module 8 reported failure due to DEVICE POST/DIAG FAILURE in device 48

any ideas how I can resolve this?.

1 REPLY
New Member

Nexus 7010 module Failure

CH-G21-N2-7010-CX01# show module 8

Mod  Ports  Module-Type                      Model              Status

---  -----  -------------------------------- ------------------ ------------

8    0      10 Gbps Ethernet XL Module                          powered-dn

Mod  Power-Status  Reason

---  ------------  ---------------------------

8    powered-dn     Reset (powered-down) because module does not boot

Mod  Sw              Hw

---  --------------  ------

Mod  MAC-Address(es)                         Serial-Num

---  --------------------------------------  ----------

Mod  Online Diag Status

---  ------------------

Chassis Ejector Support: Enabled

Ejector Status:

Top ejector CLOSE, Bottom ejector CLOSE, Module HW does support ejector based sh

utdown.

1239
Views
0
Helpful
1
Replies
CreatePlease login to create content