Nexus 7010 OSPF "passive-interface default" not showing
Hi all, I'm currently working on a plan to migrate our 6500's over to our new 7010's. At the time of the migration I want to tighten up our OSPF design and configure OSPF for "passive-interface default" then allow only those interfaces that should have OSPF neighbors to send the hellos. The issue is that the command is not showing up under the OSPF process. What's even more interesting is that the Nexus 5.x Unicast Routing Configuration Guide shows that the "passive-interface default" command should be an option to enter.
I'm currently running version 5.1(4) (though looking to upgrade to 5.2 during my migration testing) if that helps at all. I would rather configure the passive-interface via the routing process versus having to enter it on every interface.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.