Hi,
Working with Nexus 7k with NX-OS 6.0(1) code. There are no ACLs for L2/L3 traffic nor port security in this scenario. I have two (2) VDCs running and on one VDC when I issue the show mac address-table command with the dynamic, interface command options I get no results, the table freezes at the following:
Legend:
* - primary entry, G - Gateway MAC, (R) - Routed MAC, O - Overlay MAC
age - seconds since last seen,+ - primary entry using vPC Peer-Link
VLAN MAC Address Type age Secure NTFY Ports/SWID.SSID.LID
---------+-----------------+--------+---------+------+----+------------------
I have to issue a Ctrl+C to break out of this.
On the other VDC this does not seem to be an issue and I get a table of output.
When issuing a clear mac address-table dynamic, the prompt also freezes until a Ctrl+C is issued.
Any ideas are greatly apprciated.
