I have a setup in which there are two Nexus in redundancy and few 4500 connected to them. I am using VRF solution in which there are many subnets defined and the management subnets are only defined in management VRF.
Currently I am using cross VRF functionality in my core VDC so that my res VRF can communicate with managment VRF.
I also have an access list defined in the cross VRF connection to allow RES subnets to communicate with one particular server in office network , for echo-reply and between two res subnets.
Now for two subnets which are in RES VRF i have defined scope in my ip tool (QIP) and want to modify my access list to allow the DHCP requests/replies to flow. The DHCP clients will only communicate inside the "res" VRF, so the ACL does not need to allow any specific network traffic to/from these DHCP clients.
I want help in that. I am not able create this access list.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...