Nexus C1010 VSM %KERN-1-SYSTEM_MSG: received frames from duplicate VSM
I am getting the following error messages from my C1010 VSM just being installed, but not yet in production:
%KERN-1-SYSTEM_MSG: Dropping received frames from duplicate VSM saddr (0x1010000) -kernel
But the Secondary C1010 is not yet configured as well. I noticed in an earlier discussion that it may be caused by assignment of same domain ID to the VSM and the C1010. Currently the ID of the VSM is set to 1 ( I suppose that's the default).
I want to change the domain ID of the VSM to see if that can fix it but not sure about the impact on its availability as we are running other tests in the development environment. Also, is the command to change the ID of the VSM as follows as this:
vdc <VSM name> id n
And do I need to do the same on the Secondary VSM in the standby C1010 when it comes up?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...